Cost to Furnace Replacement in Seattle, WA

$3,200–$9,600 in Seattle

28% above the national average · 1.28x cost multiplier

In Seattle, a furnace replacement runs $3,200 to $9,600 on average — about 28% above what homeowners pay nationwide. The West Coast market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.

Cost Breakdown in Seattle

Line Item	Low	Mid	High
Cost per sq ft of home	$2	$4	$6
Materials	$1,792	$2,816	$5,120
Labor	$1,536	$2,176	$2,944
Permits	$256	$384	$512
Total	$3,584+28% vs. national avg	$5,760+28% vs. national avg	$9,600+28% vs. national avg

Budget

80% AFUE single-stage gas furnace, basic brand (Goodman or Amana), direct replacement with existing ductwork and venting

Mid-Range

90-95% AFUE two-stage gas furnace, mid-tier brand (Rheem, Trane, or Carrier), standard installation with smart thermostat

Premium

97-98% AFUE modulating variable-speed gas furnace, premium brand (Lennox or American Standard), with zoning controls and whole-house humidifier

Material Options

Material prices below are national averages; availability in Seattle may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
Single-Stage Gas Furnace (80% AFUE)	$2,000 - $3,500 installed	Lowest upfront cost, simple and reliable, fewer parts to fail	Highest operating costs, louder operation, less even heating	Mild climates, budget-focused homeowners, homes with high ceilings or poor insulation where efficiency gains are minimalLowest upfront cost, simple and reliable, fewer parts to fail
Two-Stage Gas Furnace (90-96% AFUE)	$3,500 - $5,500 installed	Good balance of cost and efficiency, quieter on low stage, more even temperatures	Higher upfront cost, requires PVC venting	Most homeowners in cold climates, the sweet spot of cost vs. performanceGood balance of cost and efficiency, quieter on low stage, more even temperatures
Modulating Gas Furnace (97-98% AFUE)	$5,500 - $8,500 installed	Lowest operating costs, whisper-quiet, ultra-even heating, best humidity control	Highest upfront cost, more complex repairs, longer payback period	Cold climates with high heating bills, homeowners planning to stay 10+ yearsLowest operating costs, whisper-quiet, ultra-even heating, best humidity control
Oil Furnace (83-87% AFUE)	$3,000 - $6,000 installed	Produces very hot air, works in areas without natural gas	Higher fuel costs, requires oil storage tank, more maintenance	Rural areas without natural gas service, Northeast homes with existing oil infrastructureProduces very hot air, works in areas without natural gas
Electric Furnace	$1,500 - $3,500 installed	Lowest upfront cost, no combustion or venting, 100% efficient at point of use	Very high operating costs in most areas, slow to heat	Mild climates with low heating needs, areas with very cheap electricity, supplemental heatingLowest upfront cost, no combustion or venting, 100% efficient at point of use

Other Projects in Seattle

Full Kitchen Remodel

Full Bathroom Remodel

Composite Deck Building

Back to national average for Furnace Replacement

Seattle Estimate

Typical Range

$3,200–$9,600

vs. National Average

28% above national

Cost Multiplier

1.28x

Cost Per sq ft of home

$2–$6

Estimates apply Seattle's 1.28x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →