Cost to Attic Fan Installation in Seattle, WA

$384–$1,152 in Seattle

28% above the national average · 1.28x cost multiplier

In Seattle, a attic fan installation runs $384 to $1,152 on average — about 28% above what homeowners pay nationwide. The West Coast market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.

Cost Breakdown in Seattle

Line Item	Low	Mid	High
Cost per installation	$192	$704	$2816
Materials	$192	$448	$1,024
Labor	$224	$448	$896
Permits	$0	$96	$192
Total	$416+28% vs. national avg	$992+28% vs. national avg	$2,112+28% vs. national avg

Budget

Gable-mounted electric attic fan replacement, existing wiring and vent opening, no new electrical circuit needed.

Mid-Range

Roof-mounted electric attic fan, new electrical circuit run from panel, thermostat control, standard single-story home.

Premium

Solar-powered attic fan with high-CFM rating for large attic, new roof penetration flashing, two-story home access.

Material Options

Material prices below are national averages; availability in Seattle may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
Electric Gable Attic Fan	$50-$175 for the unit	Least expensive option, no roof penetration needed, installs in existing gable vent opening, easy DIY swap if replacing old unit	Less effective than roof-mounted fans at moving hot air from the peak of the attic, requires existing or new gable vent opening	Homes with accessible gable vents, budget replacements, homeowners comfortable with basic electrical workLeast expensive option, no roof penetration needed, installs in existing gable vent opening, easy DIY swap if replacing old unit
Electric Roof-Mounted Attic Fan	$100-$350 for the unit	Installs near roof peak for maximum hot-air extraction, high-CFM models available, widely stocked at home centers	Requires new roof penetration and flashing, needs electrical circuit, ongoing electricity cost of $10-$30/year	Most single-family homes without existing gable vents, new construction, attics over 1,500 sq ftInstalls near roof peak for maximum hot-air extraction, high-CFM models available, widely stocked at home centers
Solar-Powered Attic Fan	$200-$650 for the unit	No electricity cost after installation, often no electrical permit required, operates automatically, some models qualify for federal energy tax credits	Higher upfront cost, CFM output limited by panel size and sun exposure, less effective on cloudy days or heavily shaded roofs	Sun-belt states, homeowners avoiding new electrical circuits, those seeking long-term energy savingsNo electricity cost after installation, often no electrical permit required, operates automatically, some models qualify for federal energy tax credits
Whole-House Fan (not an attic fan)	$500-$1,500 installed	Pulls cool evening air through entire living space, dramatically reduces AC load in mild climates, much higher airflow than an attic fan	Requires large ceiling opening, must be paired with open windows to work, not effective in very humid climates, higher installation cost	Dry inland climates (Mountain West, inland California, Pacific Northwest); not a substitute for attic fans in hot humid regionsPulls cool evening air through entire living space, dramatically reduces AC load in mild climates, much higher airflow than an attic fan

Other Projects in Seattle

Full Kitchen Remodel

Full Bathroom Remodel

Composite Deck Building

Back to national average for Attic Fan Installation

Seattle Estimate

Typical Range

$384–$1,152

vs. National Average

28% above national

Cost Multiplier

1.28x

Cost Per installation

$192–$2816

Estimates apply Seattle's 1.28x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →