Cost to Wood Rot Repair in Houston, TX (2026)
If you’re budgeting a wood rot repair in Houston, most projects run $432-$2,162, 14% below the $1,200 national average. What moves that number most is usually one thing: Location of Rot. On its own it can swing the cost by $300 - $8,000, so that’s the decision to slow down on before you sweat the smaller stuff.
Easiest place to save: Address the moisture source immediately - whether it is a clogged gutter, failed caulk, or poor drainage, fixing the water intrusion is the only way to prevent the rot from returning
In the South (where Houston sits): Lower labor costs across the region; Florida coastal markets slightly higher due to demand.
$432-$2,162 in Houston
14% below the national average · 0.86x cost multiplier
In Houston, a wood rot repair runs $432 to $2,162 on average - about 14% below what homeowners pay nationwide. The South market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.
Cost Breakdown in Houston
| Line Item | Low | Mid | High |
|---|---|---|---|
| Cost per area | $86 | $1038 | $8648 |
| Materials | $144 | $576 | $2,400 |
| Labor | $162 | $969 | $4,038 |
| Permits | $0 | $96 | $480 |
| Total | $306-13% vs. national avg | $1,641-14% vs. national avg | $6,918-14% vs. national avg |
Budget
Small areas of surface rot, 1-3 boards, epoxy consolidant and filler repair.
Mid-Range
Moderate rot in window sills, door frames, fascia boards, or deck posts - 4-15 linear feet replaced.
Premium
Structural rot in floor joists, sill plates, or subfloor requiring sistering or full replacement with temporary shoring.
Material Options
Material prices below are national averages; availability in Houston may shift costs slightly.
| Material | Cost/Unit | Best For |
|---|---|---|
| Epoxy Wood Filler (LiquidWood + WoodEpox) | $40-$80 per kit | Small surface rot on window sills, door frames, decorative trim, and non-structural areasExcellent for cosmetic repairs, bonds to remaining wood, sandable and paintable, no removal required |
| Pressure-Treated Lumber Replacement | $3-$8 per linear ft materials | Any wood in contact with soil, concrete, or chronically wet areas - deck posts, sill plates, framing near grade25+ year lifespan, required code material for ground contact, widely available, strong |
| Clear Heart Redwood or Cedar | $8-$20 per linear ft materials | Visible exterior trim, fascia, and decorative elements where appearance mattersNaturally rot resistant, attractive grain, good for visible areas, takes stain well |
| Composite or PVC Trim | $5-$15 per linear ft materials | Fascia boards, rake boards, window trim, and any exterior trim you never want to repair againZero rot risk, never needs painting, dimensionally stable, low lifetime maintenance cost |
| Sister Joists (Structural) | $15-$35 per linear ft materials plus significant labor | Floor joists and rafters with rot limited to sections of the member where sistering is code-acceptableRestores structural integrity alongside the damaged member, avoids full joist removal in many cases |
Other Projects in Houston
Houston Estimate
Typical Range
$432-$2,162
vs. National Average
14% below national
Cost Multiplier
0.86x
Cost Per area
$86-$8648
This 0.86x estimate prices Houston labor from BLS Occupational Employment and Wage Statistics (May 2025) and applies a lighter regional adjustment to materials and permits, which vary less by metro than labor does. Actual bids vary by contractor, project scope, and timing.
See national average costs →