Cost to Structured Wiring Installation in Phoenix, AZ (2026)
If you’re budgeting a structured wiring installation in Phoenix, most projects run $1,118-$5,588, 7% below the $2,800 national average. What moves that number most is usually one thing: Number of Drops. On its own it can swing the cost by $100 - $400 per drop, so that’s the decision to slow down on before you sweat the smaller stuff.
Easiest place to save: Run cable during any renovation that opens walls - adding ethernet when drywall is already off costs 50-70% less than retrofitting later.
In the Mountain West (where Phoenix sits): Near national average. New construction booms in Denver and Boise have created a strong structured wiring market.
$1,118-$5,588 in Phoenix
7% below the national average · 0.93x cost multiplier
In Phoenix, a structured wiring installation runs $1,118 to $5,588 on average - about 7% below what homeowners pay nationwide. The Mountain West market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.
Cost Breakdown in Phoenix
| Line Item | Low | Mid | High |
|---|---|---|---|
| Cost per room/drop | $93 | $233 | $559 |
| Materials | $390 | $975 | $2,438 |
| Labor | $720 | $1,621 | $4,052 |
| Permits | $0 | $195 | $390 |
| Total | $1,110-7% vs. national avg | $2,791-7% vs. national avg | $7,368-7% vs. national avg |
Budget
Basic retrofit: 4-6 ethernet drops, patch panel, simple distribution box
Mid-Range
Full home: 8-12 drops, Cat6 ethernet, coax, patch panel, network closet
Premium
New construction or major renovation: 20+ drops, Cat6A, fiber backbone, AV runs, full distribution
Material Options
Material prices below are national averages; availability in Phoenix may shift costs slightly.
| Material | Cost/Unit | Best For |
|---|---|---|
| Cat6 Ethernet (1Gbps Standard) | $0.20-$0.40/ft materials | Most homes - the right choice for any new installationCurrent standard, handles gigabit speeds, backward compatible, widely supported |
| Cat6A Ethernet (10Gbps Future-Proof) | $0.40-$0.60/ft materials | New construction, tech-forward homes, anyone who won't rewire for 20 yearsFull 10Gbps at 100m, ready for faster home speeds, slightly better signal isolation |
| Coaxial Cable (RG-6) | $0.15-$0.30/ft materials | Any home keeping OTA TV or cable; antenna-fed whole-home setupsRequired for cable TV, OTA antenna, and some security cameras |
| Patch Panel + Network Switch | $200-$600 installed | Any structured wiring install - a system without a patch panel isn't structured wiringCentral termination point for all drops, easy troubleshooting, clean management |
| In-Wall HDMI / Keystone | $50-$150 per location installed | TV walls where cords are currently surface-mountedClean wall-plate look for TVs, no surface cables, permanent solution |
Other Projects in Phoenix
Phoenix Estimate
Typical Range
$1,118-$5,588
vs. National Average
7% below national
Cost Multiplier
0.93x
Cost Per room/drop
$93-$559
This 0.93x estimate prices Phoenix labor from BLS Occupational Employment and Wage Statistics (May 2025) and applies a lighter regional adjustment to materials and permits, which vary less by metro than labor does. Actual bids vary by contractor, project scope, and timing.
See national average costs →