Cost to Whole-House Repiping in San Antonio, TX

$3,560–$13,350 in San Antonio

11% below the national average · 0.89x cost multiplier

Expect to pay $3,560–$13,350 for a whole-house repiping in San Antonio, about 11% below the national benchmark. The Southeast region's contractor market and material costs account for most of this difference. The detailed breakdown below shows how budget, mid-range, and premium projects compare at San Antonio prices.

Cost Breakdown in San Antonio

Line Item	Low	Mid	High
Cost per linear ft	$1	$3	$5
Materials	$1,602	$3,115	$5,340
Labor	$2,225	$4,895	$8,010
Permits	$445	$712	$1,068
Total	$4,272-11% vs. national avg	$8,722-11% vs. national avg	$14,418-11% vs. national avg

Budget

Small 1-bath home under 1,200 sq ft, CPVC pipe throughout, minimal drywall access needed, basic fixtures included.

Mid-Range

2-3 bath home, 1,500-2,500 sq ft, PEX-A piping, manifold system, standard drywall patching included.

Premium

Large home 3,000+ sq ft, 3-4 baths, PEX-A with home-run manifold, full drywall restoration, new shutoffs at all fixtures.

Material Options

Material prices below are national averages; availability in San Antonio may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
PEX-A (Uponor / Wirsbo)	$0.80-$1.50 per linear ft materials	Most flexible, fewest fittings, expansion connections are very reliable, freeze-resistant, 25-year warranty	Higher material cost than standard PEX, proprietary fitting system, requires special expansion tool	Most residential repiping projects where long-term performance is the priorityMost flexible, fewest fittings, expansion connections are very reliable, freeze-resistant, 25-year warranty
PEX-B (Crimp or Clamp)	$0.50-$1.00 per linear ft materials	Widely available, lower cost, many plumbers are familiar with it, flexible routing	Less freeze-resistant than PEX-A, fittings reduce flow slightly, more fittings needed vs. expansion type	Budget-conscious repiping in moderate climatesWidely available, lower cost, many plumbers are familiar with it, flexible routing
CPVC	$0.50-$0.90 per linear ft materials	Lowest material cost, rigid (easier to support), handles hot water well	Brittle and prone to cracking in cold temperatures, solvent cement joints require careful technique, not freeze-resistant	Warm climates like Florida, Arizona, and the Deep South where freeze risk is minimalLowest material cost, rigid (easier to support), handles hot water well
Copper	$3.00-$8.00 per linear ft materials	50+ year lifespan, resale value perception, no plastic concerns, proven track record	Most expensive option, slower installation, subject to theft, price volatile with commodity markets	High-end homes where resale value and premium materials are priorities50+ year lifespan, resale value perception, no plastic concerns, proven track record

Other Projects in San Antonio

Full Kitchen Remodel

Central AC Installation

Full Bathroom Remodel

Back to national average for Whole-House Repiping

San Antonio Estimate

Typical Range

$3,560–$13,350

vs. National Average

11% below national

Cost Multiplier

0.89x

Cost Per linear ft

$1–$5

Estimates apply San Antonio's 0.89x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →