Cost to Whole-House Repiping in Denver, CO

$4,480–$16,800 in Denver

12% above the national average · 1.12x cost multiplier

Expect to pay $4,480–$16,800 for a whole-house repiping in Denver, about 12% above the national benchmark. The Mountain West region's contractor market and material costs account for most of this difference. The detailed breakdown below shows how budget, mid-range, and premium projects compare at Denver prices.

Cost Breakdown in Denver

Line Item	Low	Mid	High
Cost per linear ft	$2	$4	$7
Materials	$2,016	$3,920	$6,720
Labor	$2,800	$6,160	$10,080
Permits	$560	$896	$1,344
Total	$5,376+12% vs. national avg	$10,976+12% vs. national avg	$18,144+12% vs. national avg

Budget

Small 1-bath home under 1,200 sq ft, CPVC pipe throughout, minimal drywall access needed, basic fixtures included.

Mid-Range

2-3 bath home, 1,500-2,500 sq ft, PEX-A piping, manifold system, standard drywall patching included.

Premium

Large home 3,000+ sq ft, 3-4 baths, PEX-A with home-run manifold, full drywall restoration, new shutoffs at all fixtures.

Material Options

Material prices below are national averages; availability in Denver may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
PEX-A (Uponor / Wirsbo)	$0.80-$1.50 per linear ft materials	Most flexible, fewest fittings, expansion connections are very reliable, freeze-resistant, 25-year warranty	Higher material cost than standard PEX, proprietary fitting system, requires special expansion tool	Most residential repiping projects where long-term performance is the priorityMost flexible, fewest fittings, expansion connections are very reliable, freeze-resistant, 25-year warranty
PEX-B (Crimp or Clamp)	$0.50-$1.00 per linear ft materials	Widely available, lower cost, many plumbers are familiar with it, flexible routing	Less freeze-resistant than PEX-A, fittings reduce flow slightly, more fittings needed vs. expansion type	Budget-conscious repiping in moderate climatesWidely available, lower cost, many plumbers are familiar with it, flexible routing
CPVC	$0.50-$0.90 per linear ft materials	Lowest material cost, rigid (easier to support), handles hot water well	Brittle and prone to cracking in cold temperatures, solvent cement joints require careful technique, not freeze-resistant	Warm climates like Florida, Arizona, and the Deep South where freeze risk is minimalLowest material cost, rigid (easier to support), handles hot water well
Copper	$3.00-$8.00 per linear ft materials	50+ year lifespan, resale value perception, no plastic concerns, proven track record	Most expensive option, slower installation, subject to theft, price volatile with commodity markets	High-end homes where resale value and premium materials are priorities50+ year lifespan, resale value perception, no plastic concerns, proven track record

Other Projects in Denver

Full Kitchen Remodel

Full Bathroom Remodel

Basement Finishing

Back to national average for Whole-House Repiping

Denver Estimate

Typical Range

$4,480–$16,800

vs. National Average

12% above national

Cost Multiplier

1.12x

Cost Per linear ft

$2–$7

Estimates apply Denver's 1.12x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →