Cost to Sump Pump Installation in Cleveland, OH

$516–$2,150 in Cleveland

14% below the national average · 0.86x cost multiplier

Homeowners in Cleveland typically spend $516–$2,150 on a sump pump installation, about 14% below the national average. Labor rates and contractor availability in the Midwest region drive much of the price difference. Permit requirements and material delivery costs also play a role. See the full tier-by-tier breakdown below before requesting bids.

Cost Breakdown in Cleveland

Line Item	Low	Mid	High
Cost per unit	$516	$1032	$2150
Materials	$172	$387	$860
Labor	$301	$559	$946
Permits	$43	$65	$86
Total	$516-14% vs. national avg	$1,011-14% vs. national avg	$2,064-14% vs. national avg

Budget

Basic pedestal sump pump (1/3 HP), existing sump pit, simple discharge line to exterior, no battery backup

Mid-Range

Submersible sump pump (1/2 HP), new sump pit if needed, PVC discharge line with check valve, basic battery backup

Premium

High-capacity submersible pump (3/4 HP), cast iron construction, battery backup system, water alarm, buried discharge line with freeze guard

Material Options

Material prices below are national averages; availability in Cleveland may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
Pedestal Sump Pump	$60 - $150 for the pump	Cheapest option, motor stays above water so it's easier to service, good for shallow pits	Louder, less powerful, shorter lifespan (5-8 years), motor is visible and takes up space	Homes with occasional minor seepage, tight budgets, shallow existing sump pitsCheapest option, motor stays above water so it's easier to service, good for shallow pits
Submersible Sump Pump (Plastic)	$100 - $250 for the pump	Quiet operation, out of sight in the pit, handles higher water volumes, sealed motor	Harder to service, plastic housing can crack, shorter life than cast iron (7-10 years)	Most standard residential installations, moderate water tablesQuiet operation, out of sight in the pit, handles higher water volumes, sealed motor
Submersible Sump Pump (Cast Iron)	$200 - $400 for the pump	Very durable (10-15 year lifespan), better heat dissipation, handles debris better, quieter	Heavier, more expensive upfront, requires a deeper pit	High water table areas, homes with frequent pump cycling, long-term reliabilityVery durable (10-15 year lifespan), better heat dissipation, handles debris better, quieter
Battery Backup Sump Pump	$200 - $600 for the backup unit	Protects against power outages, runs automatically when primary pump fails, peace of mind	Batteries need replacement every 3-5 years ($100-$200), adds complexity, takes up pit space	Areas with frequent storms and power outages, finished basements, anyone who can't afford floodingProtects against power outages, runs automatically when primary pump fails, peace of mind
Water-Powered Backup Pump	$300 - $800 for the unit	Runs indefinitely during outages (no battery), no maintenance, very reliable	Requires municipal water supply, uses water (adds to water bill), slower pumping rate, not available on wells	Homes with municipal water, extended power outage risk, homeowners who want zero-maintenance backupRuns indefinitely during outages (no battery), no maintenance, very reliable

Other Projects in Cleveland

Full Kitchen Remodel

Basement Finishing

Roof Replacement (Asphalt Shingles)

Back to national average for Sump Pump Installation

Cleveland Estimate

Typical Range

$516–$2,150

vs. National Average

14% below national

Cost Multiplier

0.86x

Cost Per unit

$516–$2150

Estimates apply Cleveland's 0.86x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →