Cost to Sump Pump Installation in Albuquerque, NM

$552–$2,300 in Albuquerque

8% below the national average · 0.92x cost multiplier

Expect to pay $552–$2,300 for a sump pump installation in Albuquerque, about 8% below the national benchmark. The Southwest region's contractor market and material costs account for most of this difference. The detailed breakdown below shows how budget, mid-range, and premium projects compare at Albuquerque prices.

Cost Breakdown in Albuquerque

Line Item	Low	Mid	High
Cost per unit	$552	$1104	$2300
Materials	$184	$414	$920
Labor	$322	$598	$1,012
Permits	$46	$69	$92
Total	$552-8% vs. national avg	$1,081-8% vs. national avg	$2,208-8% vs. national avg

Budget

Basic pedestal sump pump (1/3 HP), existing sump pit, simple discharge line to exterior, no battery backup

Mid-Range

Submersible sump pump (1/2 HP), new sump pit if needed, PVC discharge line with check valve, basic battery backup

Premium

High-capacity submersible pump (3/4 HP), cast iron construction, battery backup system, water alarm, buried discharge line with freeze guard

Material Options

Material prices below are national averages; availability in Albuquerque may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
Pedestal Sump Pump	$60 - $150 for the pump	Cheapest option, motor stays above water so it's easier to service, good for shallow pits	Louder, less powerful, shorter lifespan (5-8 years), motor is visible and takes up space	Homes with occasional minor seepage, tight budgets, shallow existing sump pitsCheapest option, motor stays above water so it's easier to service, good for shallow pits
Submersible Sump Pump (Plastic)	$100 - $250 for the pump	Quiet operation, out of sight in the pit, handles higher water volumes, sealed motor	Harder to service, plastic housing can crack, shorter life than cast iron (7-10 years)	Most standard residential installations, moderate water tablesQuiet operation, out of sight in the pit, handles higher water volumes, sealed motor
Submersible Sump Pump (Cast Iron)	$200 - $400 for the pump	Very durable (10-15 year lifespan), better heat dissipation, handles debris better, quieter	Heavier, more expensive upfront, requires a deeper pit	High water table areas, homes with frequent pump cycling, long-term reliabilityVery durable (10-15 year lifespan), better heat dissipation, handles debris better, quieter
Battery Backup Sump Pump	$200 - $600 for the backup unit	Protects against power outages, runs automatically when primary pump fails, peace of mind	Batteries need replacement every 3-5 years ($100-$200), adds complexity, takes up pit space	Areas with frequent storms and power outages, finished basements, anyone who can't afford floodingProtects against power outages, runs automatically when primary pump fails, peace of mind
Water-Powered Backup Pump	$300 - $800 for the unit	Runs indefinitely during outages (no battery), no maintenance, very reliable	Requires municipal water supply, uses water (adds to water bill), slower pumping rate, not available on wells	Homes with municipal water, extended power outage risk, homeowners who want zero-maintenance backupRuns indefinitely during outages (no battery), no maintenance, very reliable

Other Projects in Albuquerque

Central AC Installation

Roof Replacement (Asphalt Shingles)

Full Kitchen Remodel

Back to national average for Sump Pump Installation

Albuquerque Estimate

Typical Range

$552–$2,300

vs. National Average

8% below national

Cost Multiplier

0.92x

Cost Per unit

$552–$2300

Estimates apply Albuquerque's 0.92x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →