Cost to Sump Pump Installation in Dallas, TX (2026)
If you’re budgeting a sump pump installation in Dallas, most projects run $589-$1,811, 9% below the $1,200 national average. What moves that number most is usually one thing: Pump Type: Pedestal vs. Submersible. On its own it can swing the cost by $150 - $400, so that’s the decision to slow down on before you sweat the smaller stuff.
Easiest place to save: Replace a failed pump in spring before water table peaks - emergency calls during a flood event can add $100-$300 in after-hours surcharges
In the Southeast (where Dallas sits): Lower plumber labor rates; slab-on-grade construction means fewer basement installs but coastal markets add some demand.
$589-$1,811 in Dallas
9% below the national average · 0.91x cost multiplier
In Dallas, a sump pump installation runs $589 to $1,811 on average - about 9% below what homeowners pay nationwide. The Southeast market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.
Cost Breakdown in Dallas
| Line Item | Low | Mid | High |
|---|---|---|---|
| Cost per installation | $272 | $1087 | $4075 |
| Materials | $241 | $434 | $772 |
| Labor | $302 | $561 | $1,294 |
| Permits | $0 | $97 | $193 |
| Total | $543-9% vs. national avg | $1,092-9% vs. national avg | $2,259-10% vs. national avg |
Budget
Pedestal sump pump replacement in existing pit, no pit excavation needed.
Mid-Range
Submersible sump pump installation in new pit, includes basin and discharge line to exterior.
Premium
Dual-pump system with battery backup, new pit excavation, interior drain tile connection, extended discharge line.
Material Options
Material prices below are national averages; availability in Dallas may shift costs slightly.
| Material | Cost/Unit | Best For |
|---|---|---|
| Pedestal Sump Pump | $75-$200 | Shallow pits, light-duty applications, tight budget replacements where an existing pedestal pit is already in placeLower upfront cost, motor is above water so easier to service, longer motor lifespan in some cases |
| Submersible Sump Pump | $150-$400 | Most residential installations, new pit builds, basements with moderate to heavy groundwaterQuieter operation, more powerful, better for high water volumes, sealed motor handles wet conditions |
| Combination Pump with Battery Backup | $300-$700 for the system | Homes in flood-prone areas, finished basements with expensive contents, areas with frequent power outagesProvides redundancy during power outages and primary pump failure, runs automatically, peace of mind during storms |
| Water-Powered Backup Pump | $150-$300 | Homes on municipal water with good pressure, as a secondary backup where battery maintenance is a concernNo battery to replace, works indefinitely during extended outages, low maintenance |
Other Projects in Dallas
Dallas Estimate
Typical Range
$589-$1,811
vs. National Average
9% below national
Cost Multiplier
0.91x
Cost Per installation
$272-$4075
This 0.91x estimate prices Dallas labor from BLS Occupational Employment and Wage Statistics (May 2025) and applies a lighter regional adjustment to materials and permits, which vary less by metro than labor does. Actual bids vary by contractor, project scope, and timing.
See national average costs →