Cost to Sump Pump Installation in Cleveland, OH

$559–$1,720 in Cleveland

14% below the national average · 0.86x cost multiplier

Homeowners in Cleveland typically spend $559–$1,720 on a sump pump installation, about 14% below the national average. Labor rates and contractor availability in the Midwest region drive much of the price difference. Permit requirements and material delivery costs also play a role. See the full tier-by-tier breakdown below before requesting bids.

Cost Breakdown in Cleveland

Line Item	Low	Mid	High
Cost per installation	$258	$1032	$3870
Materials	$215	$387	$688
Labor	$301	$559	$1,290
Permits	$0	$86	$172
Total	$516-14% vs. national avg	$1,032-14% vs. national avg	$2,150-14% vs. national avg

Budget

Pedestal sump pump replacement in existing pit, no pit excavation needed.

Mid-Range

Submersible sump pump installation in new pit, includes basin and discharge line to exterior.

Premium

Dual-pump system with battery backup, new pit excavation, interior drain tile connection, extended discharge line.

Material Options

Material prices below are national averages; availability in Cleveland may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
Pedestal Sump Pump	$75-$200	Lower upfront cost, motor is above water so easier to service, longer motor lifespan in some cases	Noisier operation, less powerful than submersible, less effective in deep pits or high-volume flooding	Shallow pits, light-duty applications, tight budget replacements where an existing pedestal pit is already in placeLower upfront cost, motor is above water so easier to service, longer motor lifespan in some cases
Submersible Sump Pump	$150-$400	Quieter operation, more powerful, better for high water volumes, sealed motor handles wet conditions	More expensive upfront, motor harder to access for servicing since it sits inside the pit	Most residential installations, new pit builds, basements with moderate to heavy groundwaterQuieter operation, more powerful, better for high water volumes, sealed motor handles wet conditions
Combination Pump with Battery Backup	$300-$700 for the system	Provides redundancy during power outages and primary pump failure, runs automatically, peace of mind during storms	Higher upfront cost, battery must be replaced every 3-5 years ($100-$200), needs periodic testing	Homes in flood-prone areas, finished basements with expensive contents, areas with frequent power outagesProvides redundancy during power outages and primary pump failure, runs automatically, peace of mind during storms
Water-Powered Backup Pump	$150-$300	No battery to replace, works indefinitely during extended outages, low maintenance	Requires adequate city water pressure (won't work on well systems), uses municipal water which adds to water bills during activation, less effective at very high flow rates	Homes on municipal water with good pressure, as a secondary backup where battery maintenance is a concernNo battery to replace, works indefinitely during extended outages, low maintenance

Other Projects in Cleveland

Full Kitchen Remodel

Basement Finishing

Roof Replacement (Asphalt Shingles)

Back to national average for Sump Pump Installation

Cleveland Estimate

Typical Range

$559–$1,720

vs. National Average

14% below national

Cost Multiplier

0.86x

Cost Per installation

$258–$3870

Estimates apply Cleveland's 0.86x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →