Cost to Sump Pump Installation in Albuquerque, NM (2026)
If you’re budgeting a sump pump installation in Albuquerque, most projects run $601-$1,849, 8% below the $1,200 national average. What moves that number most is usually one thing: Pump Type: Pedestal vs. Submersible. On its own it can swing the cost by $150 - $400, so that’s the decision to slow down on before you sweat the smaller stuff.
Easiest place to save: Replace a failed pump in spring before water table peaks - emergency calls during a flood event can add $100-$300 in after-hours surcharges
In the Southwest (where Albuquerque sits): Denver and Salt Lake City near national average; snow melt and spring runoff drives seasonal demand spikes.
$601-$1,849 in Albuquerque
8% below the national average · 0.92x cost multiplier
Expect to pay $601-$1,849 for a sump pump installation in Albuquerque, about 8% below the national benchmark. The Southwest region's contractor market and material costs account for most of this difference. The detailed breakdown below shows how budget, mid-range, and premium projects compare at Albuquerque prices.
Cost Breakdown in Albuquerque
| Line Item | Low | Mid | High |
|---|---|---|---|
| Cost per installation | $277 | $1110 | $4161 |
| Materials | $240 | $432 | $768 |
| Labor | $315 | $584 | $1,349 |
| Permits | $0 | $96 | $192 |
| Total | $555-7% vs. national avg | $1,112-7% vs. national avg | $2,309-8% vs. national avg |
Budget
Pedestal sump pump replacement in existing pit, no pit excavation needed.
Mid-Range
Submersible sump pump installation in new pit, includes basin and discharge line to exterior.
Premium
Dual-pump system with battery backup, new pit excavation, interior drain tile connection, extended discharge line.
Material Options
Material prices below are national averages; availability in Albuquerque may shift costs slightly.
| Material | Cost/Unit | Best For |
|---|---|---|
| Pedestal Sump Pump | $75-$200 | Shallow pits, light-duty applications, tight budget replacements where an existing pedestal pit is already in placeLower upfront cost, motor is above water so easier to service, longer motor lifespan in some cases |
| Submersible Sump Pump | $150-$400 | Most residential installations, new pit builds, basements with moderate to heavy groundwaterQuieter operation, more powerful, better for high water volumes, sealed motor handles wet conditions |
| Combination Pump with Battery Backup | $300-$700 for the system | Homes in flood-prone areas, finished basements with expensive contents, areas with frequent power outagesProvides redundancy during power outages and primary pump failure, runs automatically, peace of mind during storms |
| Water-Powered Backup Pump | $150-$300 | Homes on municipal water with good pressure, as a secondary backup where battery maintenance is a concernNo battery to replace, works indefinitely during extended outages, low maintenance |
Other Projects in Albuquerque
Albuquerque Estimate
Typical Range
$601-$1,849
vs. National Average
8% below national
Cost Multiplier
0.92x
Cost Per installation
$277-$4161
This 0.92x estimate prices Albuquerque labor from BLS Occupational Employment and Wage Statistics (May 2025) and applies a lighter regional adjustment to materials and permits, which vary less by metro than labor does. Actual bids vary by contractor, project scope, and timing.
See national average costs →