How much does a sewer line repair / replacement cost in Minneapolis?

A sewer line repair / replacement in Minneapolis typically costs $1,784-$11,890, 19% above the $4,500 national average.

What is the cost per linear ft for a sewer line repair / replacement in Minneapolis?

Sewer Line Repair / Replacement in Minneapolis typically costs $59-$297 per linear ft.

How long does a sewer line repair / replacement take?

A sewer line repair / replacement typically takes 1-3 days. The minimum timeline is Half day, and complex projects can run 1-2 weeks.

Can I DIY a sewer line repair / replacement?

DIY feasibility for a sewer line repair / replacement is rated Very Low - Sewer line work requires permits, licensed plumbers, and connects to municipal sewer infrastructure. DIY sewer work creates health hazards and code violations..

Cost to Sewer Line Repair / Replacement in Minneapolis, MN (2026)

If you’re budgeting a sewer line repair / replacement in Minneapolis, most projects run $1,784-$11,890, 19% above the $4,500 national average. What moves that number most is usually one thing: Repair vs. Full Replacement. On its own it can swing the cost by $500 - $15,000, so that’s the decision to slow down on before you sweat the smaller stuff.

Easiest place to save: Always get a camera inspection ($150-$400) before agreeing to any repair or replacement - it is the only way to know exactly what is wrong and where.

$1,784-$11,890 in Minneapolis

19% above the national average · 1.19x cost multiplier

In Minneapolis, a sewer line repair / replacement runs $1,784 to $11,890 on average - about 19% above what homeowners pay nationwide. The Midwest market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.

Cost Breakdown in Minneapolis

Line Item	Low	Mid	High
Cost per linear ft	$59	$143	$297
Materials	$308	$1,230	$3,075
Labor	$1,020	$3,826	$10,202
Permits	$205	$513	$1,025
Total	$1,533+18% vs. national avg	$5,569+18% vs. national avg	$14,302+19% vs. national avg

Budget

Spot repair of a single crack or root intrusion using access from existing cleanout, no excavation required.

Mid-Range

30-50 foot section replacement, open trench, new ABS or PVC pipe, basic lawn restoration.

Premium

80-100 foot full replacement, tree root damage, trenchless CIPP lining or pipe bursting, driveway or sidewalk crossing, full restoration.

Material Options

Material prices below are national averages; availability in Minneapolis may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
PVC (Schedule 40)	$1-$3 per linear ft materials	Standard residential sewer material, smooth interior minimizes buildup, resistant to roots and chemicals, 50+ year lifespan	Requires open trench for traditional installation, joints can offset over time	Open trench replacement in most residential applicationsStandard residential sewer material, smooth interior minimizes buildup, resistant to roots and chemicals, 50+ year lifespan
ABS (Acrylonitrile Butadiene Styrene)	$1-$2.50 per linear ft materials	Lighter than PVC, widely used in western US, good chemical resistance	Not approved in all jurisdictions, can become brittle with UV exposure (for above-ground runs)	Western US residential sewer lines - check local code approvalLighter than PVC, widely used in western US, good chemical resistance
CIPP Lining (Cured-In-Place Pipe)	$80-$200 per linear ft installed	No excavation required, restores pipe strength, smooth interior improves flow, can line around bends	Requires access points, reduces pipe diameter slightly, cannot address collapsed sections	Cracked or root-infested pipe that is still structurally intact - best for under driveways and hard surfacesNo excavation required, restores pipe strength, smooth interior improves flow, can line around bends
Pipe Bursting	$60-$150 per linear ft installed	Trenchless, installs new full-diameter pipe, works for clay and cast iron lines	Requires access pits at each end, cannot navigate bends well, can disturb adjacent utilities	Full replacement of failed lines where the route is relatively straight and open trenching is difficultTrenchless, installs new full-diameter pipe, works for clay and cast iron lines

Other Projects in Minneapolis

Furnace Replacement

Attic Insulation

Basement Finishing

Back to national average for Sewer Line Repair / Replacement

Minneapolis Estimate

Typical Range

$1,784-$11,890

vs. National Average

19% above national

Cost Multiplier

1.19x

Cost Per linear ft

$59-$297

This 1.19x estimate prices Minneapolis labor from BLS Occupational Employment and Wage Statistics (May 2025) and applies a lighter regional adjustment to materials and permits, which vary less by metro than labor does. Actual bids vary by contractor, project scope, and timing.

See national average costs →