Cost to Gas Line Installation in Atlanta, GA

$180–$900 in Atlanta

10% below the national average · 0.90x cost multiplier

Homeowners in Atlanta typically spend $180–$900 on a gas line installation, about 10% below the national average. Labor rates and contractor availability in the Southeast region drive much of the price difference. Permit requirements and material delivery costs also play a role. See the full tier-by-tier breakdown below before requesting bids.

Cost Breakdown in Atlanta

Line Item	Low	Mid	High
Cost per linear ft	$14	$27	$63
Materials	$72	$180	$540
Labor	$162	$360	$1,080
Permits	$90	$135	$270
Total	$324-10% vs. national avg	$675-10% vs. national avg	$1,890-10% vs. national avg

Budget

Short run (10-15 ft) from existing supply to new appliance (dryer, stove, fireplace), accessible location, black iron pipe.

Mid-Range

25-35 foot run through wall or floor to new appliance, CSST flexible tubing, gas shutoff at appliance, tested and inspected.

Premium

60-100 foot run from meter or main supply, multiple drops for new appliances, outdoor gas line for grill or firepit, bonding and inspection.

Material Options

Material prices below are national averages; availability in Atlanta may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
Black Iron Pipe (Schedule 40)	$1-$3 per linear ft materials	Approved everywhere, extremely durable, not affected by bonding requirements, inexpensive material	Rigid - requires precise measurement and threading, more labor-intensive to install around obstacles	Short exposed runs, appliance connections, and jurisdictions with CSST restrictionsApproved everywhere, extremely durable, not affected by bonding requirements, inexpensive material
CSST (Corrugated Stainless Steel Tubing)	$2-$5 per linear ft materials	Flexible, fast installation, fewer fittings needed, runs through walls easily, resistant to movement and vibration	Requires bonding to prevent lightning-induced arcing (required by code in most states), more expensive than black iron materials	New construction and remodeling work where long flexible runs are needed - now the most common residential methodFlexible, fast installation, fewer fittings needed, runs through walls easily, resistant to movement and vibration
Copper (Type K or L)	$3-$8 per linear ft materials	Approved in some jurisdictions, good for LP gas in some applications	Not approved for natural gas in many areas, not permitted underground in most codes, expensive	LP propane applications in specific jurisdictions - check local code before specifyingApproved in some jurisdictions, good for LP gas in some applications
PE Pipe (Underground Only)	$1-$3 per linear ft materials	Required for most underground residential gas runs, flexible, corrosion-resistant	Cannot be used above grade, requires mechanical fittings and transition fittings at building entry	Outdoor underground gas runs to outbuildings, outdoor kitchens, pool heaters, and generatorsRequired for most underground residential gas runs, flexible, corrosion-resistant

Other Projects in Atlanta

Full Kitchen Remodel

Composite Deck Building

Roof Replacement (Asphalt Shingles)

Back to national average for Gas Line Installation

Atlanta Estimate

Typical Range

$180–$900

vs. National Average

10% below national

Cost Multiplier

0.90x

Cost Per linear ft

$14–$63

Estimates apply Atlanta's 0.90x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →