Cost to Drywall Repair in Oklahoma City, OK (2026)
If you’re budgeting a drywall repair in Oklahoma City, most projects run $133-$888, 11% below the $450 national average. What moves that number most is usually one thing: Hole Size. On its own it can swing the cost by $75-$1,500, so that’s the decision to slow down on before you sweat the smaller stuff.
Easiest place to save: Batch all repairs into a single contractor visit - minimum charges mean the 5th hole costs almost nothing compared to calling separately for each.
In the South Central (where Oklahoma City sits): Below-average labor rates, competitive market.
$133-$888 in Oklahoma City
11% below the national average · 0.89x cost multiplier
In Oklahoma City, a drywall repair runs $133 to $888 on average - about 11% below what homeowners pay nationwide. The South Central market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.
Cost Breakdown in Oklahoma City
| Line Item | Low | Mid | High |
|---|---|---|---|
| Cost per repair | $44 | $133 | $266 |
| Materials | $28 | $75 | $282 |
| Labor | $105 | $351 | $1,315 |
| Permits | $0 | $0 | $0 |
| Total | $133-11% vs. national avg | $426-11% vs. national avg | $1,597-11% vs. national avg |
Budget
Small nail holes and hairline cracks, single room
Mid-Range
Fist-sized hole (3-6 inch), proper patch with backer, tape, mud, texture match
Premium
Large section replacement (2+ sq ft), texture matching across multiple repairs
Material Options
Material prices below are national averages; availability in Oklahoma City may shift costs slightly.
| Material | Cost/Unit | Best For |
|---|---|---|
| Spackle / Joint Compound (Small Holes) | $5-$15 materials | Nail holes, screw holes, hairline cracksEasy to apply, fast drying, paintable, DIY-friendly |
| Patch Kit with Self-Adhesive Mesh | $10-$25 materials | Medium holes (3-6 inch) in out-of-the-way locationsEasy for 3-6 inch holes, no cutting required, good DIY option |
| California Patch (Drywall Scrap) | $5-$15 materials | Holes 3-8 inches where a clean result is neededProfessional result, uses existing drywall, no backer board needed |
| Section Replacement (Cut and Replace) | $50-$150 materials per section | Holes over 8 inches, water damage, impact damageBest result for large or irregular damage, ties into studs |
| Spray Texture | $15-$40 can | DIY texture matching on orange peel or popcorn-adjacent finishesMatches orange peel and light knockdown texture well |
Other Projects in Oklahoma City
Oklahoma City Estimate
Typical Range
$133-$888
vs. National Average
11% below national
Cost Multiplier
0.89x
Cost Per repair
$44-$266
This 0.89x estimate prices Oklahoma City labor from BLS Occupational Employment and Wage Statistics (May 2025) and applies a lighter regional adjustment to materials and permits, which vary less by metro than labor does. Actual bids vary by contractor, project scope, and timing.
See national average costs →