Cost to Whole-House Generator Installation in Dallas, TX
$6,510–$18,600 in Dallas
7% below the national average · 0.93x cost multiplier
In Dallas, a whole-house generator installation runs $6,510 to $18,600 on average — about 7% below what homeowners pay nationwide. The Southeast market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.
Cost Breakdown in Dallas
| Line Item | Low | Mid | High |
|---|---|---|---|
| Cost per unit | $3255 | $11160 | $18600 |
| Materials | $3,720 | $6,510 | $13,950 |
| Labor | $2,325 | $3,720 | $6,510 |
| Permits | $744 | $1,116 | $1,860 |
| Total | $6,789-7% vs. national avg | $11,346-7% vs. national avg | $22,320-7% vs. national avg |
Budget
10-14 kW air-cooled standby generator, 100-amp transfer switch, existing gas line
Mid-Range
20 kW air-cooled, 200-amp automatic transfer switch, new gas line run
Premium
22+ kW liquid-cooled, whole-house coverage, extended gas line, load management
Material Options
Material prices below are national averages; availability in Dallas may shift costs slightly.
| Material | Cost/Unit | Best For |
|---|---|---|
| 10-14 kW Air-Cooled Standby (Generac, Kohler) | $4,000 - $8,000 installed | Homeowners wanting essential protection without full-house coverage, budgets under $10,000Powers essential loads, most affordable standby option, widely available service |
| 20-22 kW Air-Cooled Standby | $8,000 - $15,000 installed | Most single-family homes under 3,500 sq ft, best value for near-whole-house coverageHandles most whole-house loads including HVAC, widely available, good balance of cost and coverage |
| Liquid-Cooled Standby (22+ kW) | $15,000 - $35,000 installed | Large homes, all-electric homes, homeowners in frequent-outage areas, commercial applicationsTrue whole-house coverage, quieter than air-cooled, longer lifespan (20,000+ hours), commercial-grade |
| Portable Generator + Transfer Switch | $1,500 - $4,000 installed | Occasional outages, budgets under $5,000, renters, vacation propertiesMuch lower cost, portable for other uses, no permanent installation permits in some areas |
| Propane-Fueled Standby | $7,000 - $20,000 installed (plus tank) | Rural homes without natural gas service, areas with frequent and prolonged outagesWorks where natural gas is unavailable, cleaner burning than diesel, automatic operation |
Other Projects in Dallas
Dallas Estimate
Typical Range
$6,510–$18,600
vs. National Average
7% below national
Cost Multiplier
0.93x
Cost Per unit
$3255–$18600
Estimates apply Dallas's 0.93x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.
See national average costs →