Cost to Whole-House Generator Installation in Boston, MA (2026)
If you’re budgeting a whole-house generator installation in Boston, most projects run $8,280-$23,656, 18% above the $12,000 national average. What moves that number most is usually one thing: Generator Size (kW) and Coverage. On its own it can swing the cost by $2,000 - $15,000, so that’s the decision to slow down on before you sweat the smaller stuff.
Easiest place to save: Size to essential loads only - an 11-14 kW generator protecting your critical circuits (refrigerator, sump pump, heat, lights, and outlets) costs $4,000-$7,000 less than a whole-house unit and handles 90% of outages perfectly well.
In the Northeast (where Boston sits): Frequent storm-related outages drive high demand and wait times for installation. Electrician and gas contractor labor rates are among the highest in the country. Many municipalities require special permits and inspections for permanent generator installs.
$8,280-$23,656 in Boston
18% above the national average · 1.18x cost multiplier
In Boston, a whole-house generator installation runs $8,280 to $23,656 on average - about 18% above what homeowners pay nationwide. The Northeast market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.
Cost Breakdown in Boston
| Line Item | Low | Mid | High |
|---|---|---|---|
| Cost per unit | $4140 | $14194 | $23656 |
| Materials | $4,640 | $8,120 | $17,400 |
| Labor | $3,084 | $4,934 | $8,634 |
| Permits | $928 | $1,392 | $2,320 |
| Total | $8,652+19% vs. national avg | $14,446+18% vs. national avg | $28,354+18% vs. national avg |
Budget
10-14 kW air-cooled standby generator, 100-amp transfer switch, existing gas line
Mid-Range
20 kW air-cooled, 200-amp automatic transfer switch, new gas line run
Premium
22+ kW liquid-cooled, whole-house coverage, extended gas line, load management
Material Options
Material prices below are national averages; availability in Boston may shift costs slightly.
| Material | Cost/Unit | Best For |
|---|---|---|
| 10-14 kW Air-Cooled Standby (Generac, Kohler) | $4,000 - $8,000 installed | Homeowners wanting essential protection without full-house coverage, budgets under $10,000Powers essential loads, most affordable standby option, widely available service |
| 20-22 kW Air-Cooled Standby | $8,000 - $15,000 installed | Most single-family homes under 3,500 sq ft, best value for near-whole-house coverageHandles most whole-house loads including HVAC, widely available, good balance of cost and coverage |
| Liquid-Cooled Standby (22+ kW) | $15,000 - $35,000 installed | Large homes, all-electric homes, homeowners in frequent-outage areas, commercial applicationsTrue whole-house coverage, quieter than air-cooled, longer lifespan (20,000+ hours), commercial-grade |
| Portable Generator + Transfer Switch | $1,500 - $4,000 installed | Occasional outages, budgets under $5,000, renters, vacation propertiesMuch lower cost, portable for other uses, no permanent installation permits in some areas |
| Propane-Fueled Standby | $7,000 - $20,000 installed (plus tank) | Rural homes without natural gas service, areas with frequent and prolonged outagesWorks where natural gas is unavailable, cleaner burning than diesel, automatic operation |
Other Projects in Boston
Boston Estimate
Typical Range
$8,280-$23,656
vs. National Average
18% above national
Cost Multiplier
1.18x
Cost Per unit
$4140-$23656
This 1.18x estimate prices Boston labor from BLS Occupational Employment and Wage Statistics (May 2025) and applies a lighter regional adjustment to materials and permits, which vary less by metro than labor does. Actual bids vary by contractor, project scope, and timing.
See national average costs →