Cost to Hydronic Radiant Floor Heating in Salt Lake City, UT

$10,800–$23,760 in Salt Lake City

8% above the national average · 1.08x cost multiplier

Homeowners in Salt Lake City typically spend $10,800–$23,760 on a hydronic radiant floor heating, about 8% above the national average. Labor rates and contractor availability in the Mountain West region drive much of the price difference. Permit requirements and material delivery costs also play a role. See the full tier-by-tier breakdown below before requesting bids.

Cost Breakdown in Salt Lake City

Line Item	Low	Mid	High
Cost per sq ft	$6	$13	$22
Materials	$3,780	$7,020	$12,960
Labor	$3,780	$6,480	$10,800
Permits	$324	$540	$864
Total	$7,884+8% vs. national avg	$14,580+8% vs. national avg	$25,920+8% vs. national avg

Budget

Single-zone hydronic system in new construction or accessible crawlspace, PEX tubing in a 500 sq ft area with existing boiler

Mid-Range

Multi-zone system covering 1,000 sq ft with dedicated manifold, new circulator pump, thermostat controls

Premium

Whole-house system (1,500+ sq ft) with dedicated condensing boiler, multiple zones, smart thermostats, and premium subflooring

Material Options

Material prices below are national averages; availability in Salt Lake City may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
PEX Tubing (Standard)	$0.50-$1.00/linear ft	Flexible, corrosion-resistant, easy to route, 50+ year lifespan	Cannot be exposed to UV light, needs proper oxygen barrier	Most residential hydronic radiant installationsFlexible, corrosion-resistant, easy to route, 50+ year lifespan
PEX-AL-PEX (Aluminum Layer)	$1.00-$2.00/linear ft	Holds shape after bending, built-in oxygen barrier, lower expansion	More expensive, less flexible than standard PEX, fewer fitting options	Tight routing situations and high-oxygen-sensitivity systemsHolds shape after bending, built-in oxygen barrier, lower expansion
Thin-Slab Overpour (Gypcrete)	$3-$6/sq ft installed	Excellent thermal mass, even heat distribution, quiet	Adds 1-1.5 inches of floor height, heavy, longer cure time	New construction or major renovations where floor height change is acceptableExcellent thermal mass, even heat distribution, quiet
Aluminum Transfer Plates (Staple-Up)	$2-$4/sq ft	No floor height change, works from below, faster install	Slightly less even heating, requires accessible floor joists	Retrofits with accessible basements or crawlspacesNo floor height change, works from below, faster install
Structured Insulation Panels	$4-$8/sq ft	Pre-grooved for tubing, insulation built in, fast installation	Higher material cost, adds some floor height, limited to certain tubing sizes	Retrofit over existing subfloor where access from below is not possiblePre-grooved for tubing, insulation built in, fast installation

Other Projects in Salt Lake City

Full Kitchen Remodel

Full Bathroom Remodel

Basement Finishing

Back to national average for Hydronic Radiant Floor Heating

Salt Lake City Estimate

Typical Range

$10,800–$23,760

vs. National Average

8% above national

Cost Multiplier

1.08x

Cost Per sq ft

$6–$22

Estimates apply Salt Lake City's 1.08x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →