Cost to Hydronic Radiant Floor Heating in Jacksonville, FL (2026)
If you’re budgeting a hydronic radiant floor heating in Jacksonville, most projects run $9,346-$20,561, 7% below the $14,500 national average. What moves that number most is usually one thing: New Construction vs. Retrofit. On its own it can swing the cost by $3,000 - $10,000, so that’s the decision to slow down on before you sweat the smaller stuff.
Easiest place to save: Install during new construction or a major renovation when floors are already open - saves $3,000-$8,000 in retrofit costs
In the Southeast (where Jacksonville sits): Low demand reduces pricing; fewer specialists available.
$9,346-$20,561 in Jacksonville
7% below the national average · 0.93x cost multiplier
In Jacksonville, a hydronic radiant floor heating runs $9,346 to $20,561 on average - about 7% below what homeowners pay nationwide. The Southeast market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.
Cost Breakdown in Jacksonville
| Line Item | Low | Mid | High |
|---|---|---|---|
| Cost per sq ft | $6 | $11 | $19 |
| Materials | $3,343 | $6,208 | $11,460 |
| Labor | $3,179 | $5,449 | $9,082 |
| Permits | $287 | $478 | $764 |
| Total | $6,809-7% vs. national avg | $12,613-7% vs. national avg | $22,452-6% vs. national avg |
Budget
Single-zone hydronic system in new construction or accessible crawlspace, PEX tubing in a 500 sq ft area with existing boiler
Mid-Range
Multi-zone system covering 1,000 sq ft with dedicated manifold, new circulator pump, thermostat controls
Premium
Whole-house system (1,500+ sq ft) with dedicated condensing boiler, multiple zones, smart thermostats, and premium subflooring
Material Options
Material prices below are national averages; availability in Jacksonville may shift costs slightly.
| Material | Cost/Unit | Best For |
|---|---|---|
| PEX Tubing (Standard) | $0.50-$1.00/linear ft | Most residential hydronic radiant installationsFlexible, corrosion-resistant, easy to route, 50+ year lifespan |
| PEX-AL-PEX (Aluminum Layer) | $1.00-$2.00/linear ft | Tight routing situations and high-oxygen-sensitivity systemsHolds shape after bending, built-in oxygen barrier, lower expansion |
| Thin-Slab Overpour (Gypcrete) | $3-$6/sq ft installed | New construction or major renovations where floor height change is acceptableExcellent thermal mass, even heat distribution, quiet |
| Aluminum Transfer Plates (Staple-Up) | $2-$4/sq ft | Retrofits with accessible basements or crawlspacesNo floor height change, works from below, faster install |
| Structured Insulation Panels | $4-$8/sq ft | Retrofit over existing subfloor where access from below is not possiblePre-grooved for tubing, insulation built in, fast installation |
Other Projects in Jacksonville
Jacksonville Estimate
Typical Range
$9,346-$20,561
vs. National Average
7% below national
Cost Multiplier
0.93x
Cost Per sq ft
$6-$19
This 0.93x estimate prices Jacksonville labor from BLS Occupational Employment and Wage Statistics (May 2025) and applies a lighter regional adjustment to materials and permits, which vary less by metro than labor does. Actual bids vary by contractor, project scope, and timing.
See national average costs →