Cost to Heat Pump Installation in Columbus, OH (2026)
If you’re budgeting a heat pump installation in Columbus, most projects run $3,908-$13,678, 2% below the $8,000 national average. What moves that number most is usually one thing: Heat Pump Type. On its own it can swing the cost by $3,000 - $15,000, so that’s the decision to slow down on before you sweat the smaller stuff.
Easiest place to save: Claim the federal tax credit of up to $2,000 for qualifying heat pumps under the Inflation Reduction Act
In the Midwest (where Columbus sits): Growing market with fewer installers experienced in cold-climate models. Standard units are cheap; cold-climate units are pricier.
$3,908-$13,678 in Columbus
2% below the national average · 0.98x cost multiplier
In Columbus, a heat pump installation runs $3,908 to $13,678 on average - about 2% below what homeowners pay nationwide. The Midwest market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.
Cost Breakdown in Columbus
| Line Item | Low | Mid | High |
|---|---|---|---|
| Cost per sq ft of home | $2 | $5 | $8 |
| Materials | $2,350 | $3,948 | $7,050 |
| Labor | $1,910 | $2,971 | $3,714 |
| Permits | $188 | $376 | $470 |
| Total | $4,448-1% vs. national avg | $7,859-2% vs. national avg | $13,584-3% vs. national avg |
Budget
14 SEER single-stage air-source heat pump, basic brand (Goodman or Amana), 2-3 ton, replacement into existing ductwork and electrical
Mid-Range
16-18 SEER two-stage air-source heat pump, mid-tier brand (Carrier, Trane, or Rheem), 3 ton, with smart thermostat and updated electrical
Premium
20+ SEER variable-speed cold-climate heat pump, premium brand (Mitsubishi, Daikin, or Bosch), with backup heat strip, zoning, and full system integration
Material Options
Material prices below are national averages; availability in Columbus may shift costs slightly.
| Material | Cost/Unit | Best For |
|---|---|---|
| Standard Air-Source Heat Pump | $4,000 - $8,000 installed | Moderate climates (Southeast, Mid-Atlantic, Pacific Northwest), replacing existing central ACProven technology, wide installer availability, heats and cools with one system |
| Cold-Climate Air-Source Heat Pump | $7,000 - $14,000 installed | Cold climates (Northeast, Midwest, Mountain West), homeowners wanting to eliminate gasWorks efficiently down to -15F or below, eliminates need for fossil fuel backup |
| Dual-Fuel (Hybrid) Heat Pump | $6,000 - $12,000 installed | Cold climates with existing gas infrastructure, homeowners wanting reliability and efficiencyUses heat pump when efficient, switches to gas furnace in extreme cold, lowest total bills |
| Ground-Source (Geothermal) Heat Pump | $15,000 - $35,000 installed | New construction, large properties, homeowners planning to stay 15+ years300-500% efficiency, lowest operating costs, works in all climates, lasts 20-25 years |
| Packaged Heat Pump (Rooftop/Ground) | $5,000 - $9,000 installed | Homes without basement or utility room space, mobile/manufactured homes, commercial buildingsAll-in-one outdoor unit, saves indoor space, simpler installation |
Other Projects in Columbus
Columbus Estimate
Typical Range
$3,908-$13,678
vs. National Average
2% below national
Cost Multiplier
0.98x
Cost Per sq ft of home
$2-$8
This 0.98x estimate prices Columbus labor from BLS Occupational Employment and Wage Statistics (May 2025) and applies a lighter regional adjustment to materials and permits, which vary less by metro than labor does. Actual bids vary by contractor, project scope, and timing.
See national average costs →