Cost to Geothermal Heat Pump Installation in Columbus, OH

$13,200–$30,800 in Columbus

12% below the national average · 0.88x cost multiplier

In Columbus, a geothermal heat pump installation runs $13,200 to $30,800 on average — about 12% below what homeowners pay nationwide. The Midwest market's labor costs account for most of the gap, with material pricing and local permitting fees adding to the spread. Use the cost table below to compare budget, mid-range, and premium options side by side.

Cost Breakdown in Columbus

Line Item	Low	Mid	High
Materials	$4,400	$7,920	$13,200
Labor	$5,280	$8,800	$13,200
Permits	$440	$704	$1,056
Design	$440	$1,056	$1,760
Total	$10,560-12% vs. national avg	$18,480-12% vs. national avg	$29,216-12% vs. national avg

Budget

Horizontal loop system on a property with easy digging, 2-3 ton unit for smaller home, replacing existing forced-air system

Mid-Range

Vertical loop system with 3-4 ton heat pump, new ductwork modifications, desuperheater for hot water assist

Premium

5+ ton variable-speed system with vertical loops, full ductwork redesign, zoning, hot water generation, and smart controls

Material Options

Material prices below are national averages; availability in Columbus may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
Horizontal Closed Loop	$10,000-$22,000 total	Lowest loop cost, simple installation, reliable long-term performance	Requires large yard (200+ ft trenches), disrupts landscaping, less efficient in shallow soils	Rural or suburban properties with large open yardsLowest loop cost, simple installation, reliable long-term performance
Vertical Closed Loop	$15,000-$35,000 total	Small surface footprint, works on any lot size, consistent performance year-round	Highest loop cost due to drilling, requires specialized drilling rig, longer installation	Urban or suburban lots without space for horizontal trenchingSmall surface footprint, works on any lot size, consistent performance year-round
Pond/Lake Loop	$10,000-$18,000 total	Lowest loop installation cost, no excavation, good heat exchange from water	Requires nearby body of water with sufficient depth and volume, regulatory permits	Properties with a pond or lake at least 8 feet deep and within 200 feetLowest loop installation cost, no excavation, good heat exchange from water
Open Loop (Well Water)	$12,000-$25,000 total	Highest efficiency of all loop types, lower drilling costs than closed vertical	Needs adequate well water flow (3-6 GPM per ton), water disposal required, mineral buildup risk	Properties with abundant clean groundwater and local code approval for dischargeHighest efficiency of all loop types, lower drilling costs than closed vertical

Other Projects in Columbus

Basement Finishing

Full Kitchen Remodel

Full Bathroom Remodel

Back to national average for Geothermal Heat Pump Installation

Columbus Estimate

Typical Range

$13,200–$30,800

vs. National Average

12% below national

Cost Multiplier

0.88x

Estimates apply Columbus's 0.88x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →