Cost to Attic Insulation in Albuquerque, NM

$920–$3,220 in Albuquerque

8% below the national average · 0.92x cost multiplier

Expect to pay $920–$3,220 for a attic insulation in Albuquerque, about 8% below the national benchmark. The Southwest region's contractor market and material costs account for most of this difference. The detailed breakdown below shows how budget, mid-range, and premium projects compare at Albuquerque prices.

Cost Breakdown in Albuquerque

Line Item	Low	Mid	High
Cost per sq ft	$1	$2	$3
Materials	$552	$920	$1,656
Labor	$322	$644	$920
Permits	$0	$46	$92
Design	$46	$230	$552
Total	$920-8% vs. national avg	$1,840-8% vs. national avg	$3,220-8% vs. national avg

Budget

Blown-in fiberglass over existing insulation (top-up to R-38), 1,000 sq ft attic, basic air sealing

Mid-Range

Blown-in cellulose to R-49, 1,200 sq ft attic, comprehensive air sealing of gaps, can lights, and penetrations

Premium

Spray foam on attic roof deck (creating conditioned attic), R-38 to R-49, 1,200 sq ft, full air sealing, with baffles and ventilation work

Material Options

Material prices below are national averages; availability in Albuquerque may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
Blown-In Fiberglass	$0.60 - $1.20 per sq ft	Cheapest option, non-combustible, does not absorb moisture, pest-resistant	Lower R-value per inch (R-2.5), settles 10-15% over time, does not air seal	Budget topping-off over existing insulation, DIY-friendly with rental blowerCheapest option, non-combustible, does not absorb moisture, pest-resistant
Blown-In Cellulose	$0.80 - $1.50 per sq ft	Good R-value per inch (R-3.5), fills gaps better than fiberglass, made from recycled paper	Absorbs moisture if attic has leaks, settles 15-20% over time, fire retardant can irritate skin	Most attic insulation projects - best balance of cost, performance, and air sealingGood R-value per inch (R-3.5), fills gaps better than fiberglass, made from recycled paper
Fiberglass Batts	$0.70 - $1.50 per sq ft	Widely available, familiar to installers, good for standard joist spacing	Hard to install properly around obstacles, gaps reduce effectiveness dramatically	Open attic floors with consistent joist spacing and no obstructionsWidely available, familiar to installers, good for standard joist spacing
Open-Cell Spray Foam	$1.50 - $2.50 per sq ft	Excellent air sealing, fills irregular spaces, good soundproofing	More expensive, requires professional installation, absorbs moisture	Attic roof deck application in mild climates, soundproofing between floorsExcellent air sealing, fills irregular spaces, good soundproofing
Closed-Cell Spray Foam	$2.50 - $5.00 per sq ft	Highest R-value per inch (R-6.5), air and moisture barrier, adds structural rigidity	Most expensive option, requires professional application, can trap moisture if applied incorrectly	Attic roof deck in cold/wet climates, creating a conditioned attic for HVAC equipmentHighest R-value per inch (R-6.5), air and moisture barrier, adds structural rigidity

Other Projects in Albuquerque

Central AC Installation

Roof Replacement (Asphalt Shingles)

Full Kitchen Remodel

Back to national average for Attic Insulation

Albuquerque Estimate

Typical Range

$920–$3,220

vs. National Average

8% below national

Cost Multiplier

0.92x

Cost Per sq ft

$1–$3

Estimates apply Albuquerque's 0.92x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →