How much does a entry door replacement cost in El Paso?

A entry door replacement in El Paso typically costs $857-$3,001, 14% below the $1,800 national average.

How long does a entry door replacement take?

A entry door replacement typically takes 4-6 hours. The minimum timeline is 2 hours, and complex projects can run 2 days.

Can I DIY a entry door replacement?

DIY feasibility for a entry door replacement is rated Difficult.

Cost to Entry Door Replacement in El Paso, TX (2026)

If you’re budgeting a entry door replacement in El Paso, most projects run $857-$3,001, 14% below the $1,800 national average. What moves that number most is usually one thing: Door Material. On its own it can swing the cost by $300 - $3,000, so that’s the decision to slow down on before you sweat the smaller stuff.

Easiest place to save: Choose fiberglass over solid wood - you'll save $500-$1,500 while getting better weather resistance and similar curb appeal

In the Southwest (where El Paso sits): Lower labor costs, hurricane-rated doors may add cost in coastal areas.

$857-$3,001 in El Paso

14% below the national average · 0.86x cost multiplier

Expect to pay $857-$3,001 for a entry door replacement in El Paso, about 14% below the national benchmark. The Southwest region's contractor market and material costs account for most of this difference. The detailed breakdown below shows how budget, mid-range, and premium projects compare at El Paso prices.

Cost Breakdown in El Paso

Line Item	Low	Mid	High
Materials	$376	$940	$2,350
Labor	$231	$330	$528
Permits	$0	$0	$47
Total	$607-19% vs. national avg	$1,270-15% vs. national avg	$2,925-13% vs. national avg

Budget

Basic steel entry door with standard frame, builder-grade hardware

Mid-Range

Fiberglass door with decorative glass insert, upgraded hardware and weatherstripping

Premium

Solid wood or premium fiberglass with sidelights, transom, custom finish, and smart lock

Material Options

Material prices below are national averages; availability in El Paso may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
Steel	$300-$700/door	Most affordable, strong, good security, low maintenance	Can dent, poor insulation without foam core, prone to rust at edges	Budget projects, rental properties, side/back entriesMost affordable, strong, good security, low maintenance
Fiberglass	$500-$2,000/door	Won't rot, dent, or rust. Can mimic wood grain. Excellent insulation	Higher cost than steel, can crack on impact, limited repair options	Most homeowners - best all-around performance and valueWon't rot, dent, or rust. Can mimic wood grain. Excellent insulation
Solid Wood	$1,000-$3,000/door	Beautiful natural appearance, can be refinished, excellent curb appeal	Requires regular maintenance, swells/warps with humidity, most expensive	High-end homes, historic properties, covered entriesBeautiful natural appearance, can be refinished, excellent curb appeal
Wood with Fiberglass Cladding	$1,500-$2,500/door	Wood interior appearance with weather-resistant exterior, less maintenance than solid wood	Expensive, heavier than standard fiberglass	Homeowners who want wood aesthetics without full maintenance commitmentWood interior appearance with weather-resistant exterior, less maintenance than solid wood

Other Projects in El Paso

Central AC Installation

Roof Replacement (Asphalt Shingles)

Full Kitchen Remodel

Back to national average for Entry Door Replacement

El Paso Estimate

Typical Range

$857-$3,001

vs. National Average

14% below national

Cost Multiplier

0.86x

This 0.86x estimate prices El Paso labor from BLS Occupational Employment and Wage Statistics (May 2025) and applies a lighter regional adjustment to materials and permits, which vary less by metro than labor does. Actual bids vary by contractor, project scope, and timing.

See national average costs →