Cost to Concrete Crack Repair in Atlanta, GA (2026)

If you’re budgeting a concrete crack repair in Atlanta, most projects run $221-$884, 12% below the $500 national average. What moves that number most is usually one thing: Crack Width and Depth. On its own it can swing the cost by $5-$25/linear ft, so that’s the decision to slow down on before you sweat the smaller stuff.

Easiest place to save: Fill small cracks yourself as they appear. A $10-$15 tube of polyurethane concrete caulk handles most hairline cracks. Ignoring a small crack for two years allows water to widen and deepen it into a $500-$1,500 problem.

In the Southeast (where Atlanta sits): Lower labor costs; expansive clay soils common in GA, AL, TX.

$221-$884 in Atlanta

12% below the national average · 0.88x cost multiplier

Homeowners in Atlanta typically spend $221-$884 on a concrete crack repair, about 12% below the national average. Labor rates and contractor availability in the Southeast region drive much of the price difference. Permit requirements and material delivery costs also play a role. See the full tier-by-tier breakdown below before requesting bids.

Cost Breakdown in Atlanta

Line ItemLowMidHigh
Cost per $NaN$NaN$NaN
Materials$38$143$380
Labor$128$343$771
Permits$0$0$0
Total$166-13% vs. national avg$486-12% vs. national avg$1,151-11% vs. national avg

Budget

Cleaning and filling hairline or surface cracks (under 1/4 inch wide) in a driveway or patio with polyurethane or concrete caulk. Up to 15-20 linear feet of minor cracks.

Mid-Range

Chiseling out and filling 20-40 linear feet of cracks in a driveway or patio with epoxy injection or polymer-modified filler. Includes prep, fill, and sealcoat over the repaired area.

Premium

Structural crack repair in a foundation wall or garage floor - epoxy injection under pressure for active cracks, or polyurethane foam injection to stop water infiltration. 40-80 linear feet, includes sealing.

Material Options

Material prices below are national averages; availability in Atlanta may shift costs slightly.

MaterialCost/UnitBest For
Polyurethane Concrete Caulk$8-$20/tubeControl joint cracks, cosmetic surface cracks in driveways and walkwaysFlexible, handles freeze-thaw cycles, good adhesion, easy DIY application
Epoxy Injection$25-$60/cartridgeStructural cracks in foundations, garage floors, and walls where movement has stoppedBonds stronger than the surrounding concrete, good for structural cracks, creates a rigid fill
Polyurethane Foam Injection$30-$80/cartridgeBasement and foundation cracks with active water infiltrationExpands to fill irregular voids, works on wet and actively leaking cracks, flexible after cure
Hydraulic Cement$15-$30/bagEmergency patching of actively leaking holes and cracks in basement wallsSets very fast (3-5 minutes), expands slightly, stops active water flow
Polymer-Modified Concrete Patch$15-$35/bagWide surface cracks and spalled areas in driveways, steps, and garage floorsGood adhesion, handles traffic well, can be shaped and tooled, matches surrounding concrete better

Other Projects in Atlanta

Atlanta Estimate

Typical Range

$221-$884

vs. National Average

12% below national

Cost Multiplier

0.88x

Cost Per

$NaN-$NaN

This 0.88x estimate prices Atlanta labor from BLS Occupational Employment and Wage Statistics (May 2025) and applies a lighter regional adjustment to materials and permits, which vary less by metro than labor does. Actual bids vary by contractor, project scope, and timing.

See national average costs →