Cost to Concrete Crack Repair in Albuquerque, NM

$230–$920 in Albuquerque

8% below the national average · 0.92x cost multiplier

Expect to pay $230–$920 for a concrete crack repair in Albuquerque, about 8% below the national benchmark. The Southwest region's contractor market and material costs account for most of this difference. The detailed breakdown below shows how budget, mid-range, and premium projects compare at Albuquerque prices.

Cost Breakdown in Albuquerque

Line Item	Low	Mid	High
Cost per	$NaN	$NaN	$NaN
Materials	$37	$138	$368
Labor	$138	$368	$828
Permits	$0	$0	$0
Total	$175-8% vs. national avg	$506-8% vs. national avg	$1,196-8% vs. national avg

Budget

Cleaning and filling hairline or surface cracks (under 1/4 inch wide) in a driveway or patio with polyurethane or concrete caulk. Up to 15-20 linear feet of minor cracks.

Mid-Range

Chiseling out and filling 20-40 linear feet of cracks in a driveway or patio with epoxy injection or polymer-modified filler. Includes prep, fill, and sealcoat over the repaired area.

Premium

Structural crack repair in a foundation wall or garage floor - epoxy injection under pressure for active cracks, or polyurethane foam injection to stop water infiltration. 40-80 linear feet, includes sealing.

Material Options

Material prices below are national averages; availability in Albuquerque may shift costs slightly.

Material	Cost/Unit	Pros	Cons	Best For
Polyurethane Concrete Caulk	$8-$20/tube	Flexible, handles freeze-thaw cycles, good adhesion, easy DIY application	Cosmetic - visible repair line, may shrink slightly over time	Control joint cracks, cosmetic surface cracks in driveways and walkwaysFlexible, handles freeze-thaw cycles, good adhesion, easy DIY application
Epoxy Injection	$25-$60/cartridge	Bonds stronger than the surrounding concrete, good for structural cracks, creates a rigid fill	Rigid - can crack again if movement continues, not suitable for actively wet cracks	Structural cracks in foundations, garage floors, and walls where movement has stoppedBonds stronger than the surrounding concrete, good for structural cracks, creates a rigid fill
Polyurethane Foam Injection	$30-$80/cartridge	Expands to fill irregular voids, works on wet and actively leaking cracks, flexible after cure	Less structural strength than epoxy, visible foam may need trimming	Basement and foundation cracks with active water infiltrationExpands to fill irregular voids, works on wet and actively leaking cracks, flexible after cure
Hydraulic Cement	$15-$30/bag	Sets very fast (3-5 minutes), expands slightly, stops active water flow	Brittle, no flexibility, cannot be used in wide expansion joints, shrinks over time	Emergency patching of actively leaking holes and cracks in basement wallsSets very fast (3-5 minutes), expands slightly, stops active water flow
Polymer-Modified Concrete Patch	$15-$35/bag	Good adhesion, handles traffic well, can be shaped and tooled, matches surrounding concrete better	Requires chiseling crack wider first for proper keying, not flexible	Wide surface cracks and spalled areas in driveways, steps, and garage floorsGood adhesion, handles traffic well, can be shaped and tooled, matches surrounding concrete better

Other Projects in Albuquerque

Central AC Installation

Roof Replacement (Asphalt Shingles)

Full Kitchen Remodel

Back to national average for Concrete Crack Repair

Albuquerque Estimate

Typical Range

$230–$920

vs. National Average

8% below national

Cost Multiplier

0.92x

Cost Per

$NaN–$NaN

Estimates apply Albuquerque's 0.92x regional cost multiplier to national averages. Actual bids vary by contractor, project scope, and timing.

See national average costs →